Programming - Transmitter

NOTE: The remote keyless entry module erases all previous transmitters from memory when the transmitters are programmed or reprogrammed. The remote entry receiver module can store up to four transmitters in memory.

To program (or reprogram) transmitter(s) into the remote entry receiver module, perform the following steps:

1. Turn ignition switch to the ON position and momentarily short the two terminals of the Program Connector (J4), a two-pin connector taped to the wire assembly and located behind the glove compartment. All doors should lock then unlock. Remove shorting pin.
2. Press any button on transmitter. All doors should lock then unlock to verify the transmitter has been programmed. If door locks do not respond, press button again (up to three times maximum with the same transmitter). If door locks still fail to respond, go to Pinpoint Test F.
3. Repeat the above step to program additional transmitters into the remote entry receiver module (up to four transmitters maximum).
4. Turn ignition switch OFF. All doors should lock then unlock.
5. Check operation.