Disassembly and Assembly

DISASSEMBLY
1. Hold the voltage regulator in one hand and pry off the cap covering the A screw head with a screwdriver.

NOTE: If the alternator (10346) assembly needs further service, replace as an assembly.

2. Remove two screws (T20 TORX(R) type head) attaching the voltage regulator to the alternator brush and terminal holder (10320). Separate the voltage regulator from alternator brush and terminal holder.

ASSEMBLY
1. Attach alternator brush and terminal holder to voltage regulator with two screws.
2. Replace cap on the head of the A terminal screw.
3. Depress the alternator brushes (10347) into the alternator brush and terminal holder and hold the alternator brushes in position by inserting a standard-size paper clip or equivalent through both the location hole in the voltage regulator and through the holes in the alternator brushes.

NOTE: If alternator is found defective replace as an assembly, parts are not serviced separately.