Removal & Installation

1. Disconnect battery ground cable.
2. Disconnect wire harness attachments to the alternator.
3. Remove drive belt.
4. Remove three attaching bolts and alternator.
5. To install, reverse removal procedure. Tighten bolts to 40-55 Nm (30-41 ft lb).

NOTE: Vehicle specific information about operation, stored in PCM using battery backed up memory, may be lost when battery is disconnected. If this occurs poor engine performance, stalling and other driveability problems may occur. It may be necessary to drive the vehicle for up to 10 miles to allow the PCM to relearn this information.