Ignition Lock: Service and Repair

REMOVAL
1. Disconnect battery ground cable.
2. Turn ignition switch to the Run position.
3. Insert a suitable 1/8 inch rod or pin through hole in column cover into lock housing and depress retaining pin.
4. Remove lock from housing.

INSTALLATION
1. Set lock cylinder to Run position
2. Depress retaining pin, then install lock cylinder.
3. Ensure lock cylinder is fully seated before rotating lock, then rotate lock to Off position.
4. Rotate lock to all positions to ensure correct operation.
5. Connect battery ground cable.

NOTE: Vehicle specific information about operation, stored in PCM using battery backed up memory, may be lost when battery is disconnected. If this occurs poor engine performance, stalling and other driveability problems may occur. It may be necessary to drive the vehicle for up to 10 miles to allow the PCM to relearn this information.