Differential and Gearset
DISASSEMBLYDifferential And Gearset:
1. Remove rear planet support, No. 15 needle bearing, park gear, No. 16 needle bearing and final drive sun gear by lifting off.
Rear Planet Support:
2. Check to be sure hole in bushing in rear planet is aligned with lubrication passage. If not, replace support, as bushing is not serviced.
Seal Removal:
3. Remove seal and discard.
Snap Ring:
4. Check snap ring to verify that it is fully seated in its groove.
Speedometer Drive Gear Removal:
5. If necessary remove speedometer drive gear by gently prying off with a screwdriver.
ASSEMBLY
Speedometer Drive Gear Installation:
1. If removed, position speedometer drive gear and gently tap into place using soft-faced hammer. Be sure gear is fully seated.
2. Install rear lubrication tube seal in support.
3. Slide final drive sun gear, No. 16 needle bearing, park wheel, No. 15 needle bearing and rear planet support into place.