K3 Verify Integrity of RABS Sensor Connection

- Verify ignition is OFF.

- Remove RABS sensor harness connector.

- Inspect RABS connector for contamination and bent or loose terminals.

- Gently pull on Circuit 519 (LG/BK) behind Pin B of harness connector.

- Gently pull on Circuit 523 (R/PK) behind Pin A of harness connector.

- Are all connections clean and secure?

YES -- Reinstall RABS sensor connector. Go to K4.

NO -- Terminal(s) in component connector are corroded, bent, or loose. Service terminal or connector as needed. If not serviceable, Replace RABS sensor. Go to K8.

NO -- Terminal(s) in harness connector are corroded, bent, or move back or come free of connector. Service terminal or connector as needed. Go to K8.