P3 Verify Integrity of RABS Sensor Connection

- Remove RABS sensor harness connector.

- Inspect RABS sensor component connector.

- Gently pull on wire behind Pin B of harness connector.

- Gently pull on wire behind Pin A of harness connector.

- Are all connections clean and secure?

YES -- Leave RABS sensor connector disconnected. Go to P4.

NO -- Terminal(s) in component connector are loose, bent, deformed, or corroded. Service terminals or connector as needed, if not serviceable, Replace RABS sensor. Go to P7.

NO -- Terminal(s) in harness connector move back or come free of connector. Service terminal or connector as needed. Go to P7.