Clearing Continuous Memory

HOW TO CLEAR THE CONTINUOUS MEMORY

NOTE: Do not disconnect battery to clear continuous memory. This will erase the Keep Alive Memory (KAM) information which may cause a driveability concern.

1. Run the Key ON Engine OFF Self-Test.
2. When the Diagnostic Trouble Codes (DTCs) begin to be displayed, deactivate self-test:
- Super STAR II tester -- Unlatching the center button (up position).
- Scan tool -- Pushing the STOP button.
- All others -- Remove the jumper wire from between Self-Test Input (STI) connector and the signal return pin of the Data Link Connector (DLC).
3. Continuous memory will be erased in the Powertrain Control Module (PCM).