PCM - MIL ON/Code P1742 Set
Article No.96-5-16
02/26/96
^ MALFUNCTION INDICATOR LAMP (MIL)
ILLUMINATION - CODE P1742 STORED IN
MEMORY - NO DRIVEABILITY CONCERNS
PRESENT - VEHICLES WITH E4OD TRANSMISSION
BUILT THROUGH 10/15/95
^ MALFUNCTION INDICATOR LAMP (MIL)
ILLUMINATION - CODE P1742 STORED IN
MEMORY - NO DRIVEABILITY CONCERNS
PRESENT - VEHICLES WITH E4OD
TRANSMISSIONS BUILT THROUGH 10/15/95
^ LAMP - MALFUNCTION INDICATOR LAMP (MIL)
ILLUMINATION - CODE P1742 STORED IN
MEMORY - NO DRIVEABILITY CONCERNS
PRESENT - VEHICLES WITH E4OD TRANSMISSION
BUILT THROUGH 10/15/95
LIGHT TRUCK:
1996 BRONCO, ECONOLINE, F SUPER DUTY, F-150-350 SERIES
CALIBRATION:
6-52R-R06, 6-52J-R06, 6-52K-RO6, 6-76R-R10, 6-765-R10, 6-76T-R10, 6-64E-R10, 6-645-R10, 6-64K-R10, 6-64R-R10, 6-648-R10, 6-64T-R10, 6-64H-R10, 6-64L-R10, 6-54J-R10, 6-54M-R10, 6-54P-R10, 6-540-R10, 6-98Q-R06, 6-98S-R06, 6-98P-R06, 6-98R-R06
WARNING:
THIS MODIFICATION IS AUTHORIZED ONLY FOR THE LISTED ENGINE. PERFORMING THIS MODIFICATION ON OTHER ENGINE CALIBRATIONS IS UNAUTHORIZED AND COULD CREATE LIABILITY UNDER APPLICABLE FEDERAL OR LOCAL LAWS. Refer to the Calibration Chart in this bulletin.
ISSUE:
The "Check Engine" lamp may illuminate and a Code P1742 may be stored in memory. There may be no driveability concerns present. This may be caused by an improper signaling within the Powertrain Control Module (PCM).
ACTION:
Reprogram the PCM. Refer to the following Service Procedure for details.
NOTE:
PART NUMBER INFORMATION CONCERNING REPLACEMENT PCMs WILL BE PUBLISHED IN AN UPCOMING TSB. DEALERS WITHOUT SERVICE BAY DIAGNOSTIC SYSTEM (SBDS) WILL REFER TO AN APPLICATION CHART THAT WILL APPEAR THE UPCOMING TSB FOR CORRECT PCM REPLACEMENT.
SERVICE PROCEDURE
1. Verify there are no other codes stored in memory. If codes other than Pi742 are stored, repair as required. Refer to the appropriate Service Manual for details.
2. Dealers with SBDS are required to reprogram the PCM using SBDS.
Obtain an Authorized Modifications Decal and list the date, dealer number, and summary of modifications performed. Select a prominent place adjacent to the Vehicle Emission Control Information Decal suitable for installing the Authorized Modifications Decal. Clean the area, install the decal, and cover it with a clear plastic decal shield.
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To bumper Warranty Coverage And Emissions Warranty Coverage
OPERATION DESCRIPTION TIME
960516A Reprogram Powertrain 0.2 Hr.
Control Module (PCM)
DEALER CODING
CONDITION
BASIC PART NO. CODE
RECAL 08
OASIS CODES: 206000, 698298