PCM - MIL ON/DTC P1742 Set
Article No.96-6-9
03/11/96
^ MALFUNCTION INDICATOR LAMP (MIL) ILLUMINATION - CODE P1742 STORED IN MEMORY - NO DRIVEABILITY CONCERNS PRESENT - VEHICLES WITH E4OD TRANSMISSION BUILT THROUGH 10/15/95
^ MALFUNCTION INDICATOR LAMP (MIL) ILLUMINATION - CODE P1742 STORED IN MEMORY - NO DRIVEABILITY CONCERNS PRESENT - VEHICLES WITH E4OD TRANSMISSIONS BUILT THROUGH 10/15/95
^ LAMP - MALFUNCTION INDICATOR LAMP (MIL) ILLUMINATION - CODE P1742 STORED IN MEMORY - NO DRIVEABILITY CONCERNS PRESENT - VEHICLES WITH E4OD TRANSMISSION BUILT THROUGH 10/15/95
LIGHT TRUCK:
1996 BRONCO, ECONOLINE, F SUPER DUTY, F-150-350 SERIES
CALIBRATION:
6-52R-R06, 6-52J-R06, 6-52K-R06, 6-76R-R10, 6-76S-R10, 6-76T-R10, 6-64E-R10, 6-64S-R10, 6-64K-R10, 6-64R-R10, 6-64B-R10, 6-64T-R10, 6-64H-R10, 6-64L-R10, 6-54J-R10, 6-54M-R10, 6-54P-R10,
6-540-R10, 6-980-R06, 6-98S-0O6, 6-98P-R06, 6-98R-R06
WARNING:
THIS MODIFICATION IS AUTHORIZED ONLY FOR THE LISTED ENGINE. PERFORMING THIS MODIFICATION ON OTHER ENGINE CALIBRATIONS IS UNAUTHORIZED AND COULD CREATE LIABILITY UNDER APPLICABLE FEDERAL OR LOCAL LAWS.
ISSUE:
The "Check Engine" lamp may illuminate and a Code P1742 may be stored in memory. There may be no driveability concerns present. This may be caused by an improper signaling within the Powertrain Control Module (PCM).
ACTION:
Reprogram or replace the PCM. Refer to the following Service Procedure for details.
NOTE:
DEALERS WITH SBDS ARE REQUIRED TO OBTAIN REGIONAL APPROVAL WHEN IT IS NECESSARY TO REPLACE THE PCM.
SERVICE PROCEDURE
1. Verify that there are no other codes stored in memory. If codes other than P1742 are stored, repair as required. Refer to the appropriate Service Manual for details.
2. Dealers with SBDS are required to reprogram the PCM using SBDS. Dealers without SBDS, refer to the Application Chart for correct PCM replacement.
Obtain an Authorized Modifications Decal and list the date, dealer number, and summary of modifications performed. Select a prominent place adjacent to the Vehicle Emission Control Information Decal suitable for installing the Authorized Modifications Decal. Clean the area, install the decal, and cover it with a clear plastic decal shield.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
OPERATION DESCRIPTION TIME
960609A Reprogram Powertrain 0.3 Hr.
Control Module (PCM)
960609B Replace Powertrain Control 0.3 Hr.
Module (PCM) - Econoline
960609C Replace Powertrain Control 0.8 Hr.
Module (PCM) - F-Series,
Bronco
DEALER CODING
CONDITION
BASIC PART NO. CODE
RECAL 08
OASIS CODES: 206000, 698298