Electronic Brake Control Module: Service and Repair

REMOVAL
1. Disconnect the battery ground cable (14301).
2. From beneath the battery tray (10732), disconnect the electrical connector from the anti-lock brake control module (2B373).

Control Module:

3. Raise and support the vehicle.
4. Remove the LH tire and wheel assembly.
5. Remove the LH front fender apron (16055) (eight screws).
6. From beneath the LH inner fender, remove the module-to-inner fender screw.
7. Slide the anti-lock brake control module out of its slot and remove it from the vehicle.

INSTALLATION
To install, reverse the removal procedure. Tighten the module-to-inner fender screw to 6-8 Nm (53-71 in lb).