Post-Service Procedures

Post-Service Procedures
After the service is complete and the fuel charging system component is installed into the vehicle, the following steps must be taken:

1. Install fuel tank filler cap at fuel tank.

2. Connect battery ground cable.

3. Add engine coolant (if required).

WARNING: THE FUEL SYSTEM IS NORMALLY PRESSURIZED TO 276 KPA (40 PSI). USE CARE WHEN SERVICING THE FUEL SYSTEM OR POSSIBLE PERSONAL INJURY MAY OCCUR.

NOTE: Check all connections at fuel injection supply manifold, fuel injectors, push connect fittings and other appropriate areas.

4. Turn ignition switch from ON /OFF position several times without starting engine to check for fuel leaks.

5. Start engine and warm to operating temperature. Check for coolant leak if coolant was removed.

6. Perform Powertrain Control Module Self Test to check systems function: Testing and Inspection