Post-Service Procedures

1. Install fuel tank filler cap at fuel tank.
2. Connect battery ground cable.
3. Add engine coolant (if required).

WARNING: THE FUEL SYSTEM IS NORMALLY PRESSURIZED TO 276 kPa (40 PSI). USE CARE WHEN SERVICING THE FUEL SYSTEM OR PERSONAL INJURY MAY OCCUR.

NOTE: Check all connections at fuel injection supply manifold, fuel injectors, fuel line push connect fittings.

4. Turn ignition switch ON/OFF several times without starting engine to pressurize system. Check for fuel leaks.
5. Start engine and warm to operating temperature. Check for engine coolant leak if coolant was removed.
6. Perform Powertrain Control Module Self-Test to check system function.