Manufacturer Code Charts: 10: 10.2

- Remove speed sensor connector.

- Inspect speed sensor component connector.

- Gently pull on wire behind Pin B of harness connector.

- Gently pull on wire behind Pin A of harness connector.

- Are all connections clean and secure?

YES -- Leave speed sensor connector disconnected. Go to 10.3. 10.3

NO -- Terminal(s) in component connector are loose, bent, deformed, or corroded. Service terminal or connectors as needed, if not serviceable, replace speed sensor. Go to 10.7. 10.7

NO -- Terminal(s) in harness connector move back or come free of connector. Service terminal or connector as needed. Go to 10.7. 10.7