Manufacturer Code Charts: 10: 10.6

- This step requires that a valid diagnostic trouble code has been obtained, all prior diagnostic steps have been completed, and the affected wiring integrity has been verified.

NOTE: Make sure to complete all steps. Failure to do so could cause replacement of good parts.

- Have all prior diagnostic steps been completed as described above?

YES -- Replace anti-lock electronic control module. Go to step 10.7. 10.7

YES -- If anti-lock electronic control module has been replaced and no resolution has been reached, replace rear axle speed sensor. Go to step 10.7. 10.7

NO -- Go to diagnostic step last completed and continue.