Manufacturer Code Charts: 3: 3.1

- Turn ignition to the OFF position.

- Disconnect battery ground cable.

- Remove the anti-lock electronic control module connector.

- Inspect anti-lock electronic control module Pins 8 and 14.

- Pull gently on each wire just behind Pins 8 and 14 on harness connector.

- Are connections clean and secure?

YES -- Leave anti-lock electronic control module connector disconnected. Go to 3.2. 3.2

NO -- Terminal(s) in anti-lock electronic control module connector are loose, bent, deformed, corroded, or missing. Service terminal or connector as needed.

NO -- If not serviceable, replace anti-lock electronic control module. Go to 3.6. 3.6


NO -- Terminals 8 or 14 in harness connector move back or come free of connector. Service terminal or connector as needed. Go to 3.6. 3.6