Manufacturer Code Charts: 4: 4.1

- Remove RABS valve connector.

- Inspect RABS valve component connector Pins 2 and 3.

- Inspect RABS valve harness connector Pins 2 and 3.

- Pull gently on Pin 2 wire just behind the harness connector.

- Pull gently on Pin 3 just behind the harness connector.

- Are connections clean and secure?

YES -- Leave RABS valve connector disconnected. Go to 4.2. 4.2

NO -- Terminals in RABS valve connector are loose, bent, deformed, corroded, or missing. Service terminal or connector as needed. If not serviceable, Replace RABS valve. GO to 4.10. 4.10

NO -- Terminal(s) in harness connector move back or come free of connector. Service terminal or connector as needed. Go to 4.10. 4.10