Manufacturer Code Charts: 4: 4.2

- Turn the ignition OFF.

- Disconnect battery ground cable.

- Inspect anti-lock electronic control module component connector Pin 6.

- Inspect anti-lock electronic control module harness connector Pin 6.

- Pull gently on Pin 6 wire just behind the harness connector.

- Are connections clean and secure?

YES -- Leave anti-lock electronic control module connector disconnected. GO to 4.3. 4.3

NO -- Terminal(s) in anti-lock electronic control module connector are loose, bent, deformed, corroded, or missing. Service terminal or connector as needed.

NO -- If not serviceable, Replace anti-lock electronic control module. Go to 4.10. 4.10


NO -- Terminal 6 in harness connector moves back or comes free of connector. Service terminal or connector as needed. Go to 4.10. 4.10