Manufacturer Code Charts: 6: 6.1

- Turn ignition OFF.

- Disconnect battery ground cable.

- Remove the anti-lock electronic control module connector.

- Inspect anti-lock electronic control module component connector for contamination and loose or bent terminals.

- Pull gently on Circuit 519 (LG/BK) just behind Pin 3 on the harness connector.

- Pull gently on Circuit 523 (R/PK) just behind Pin 10 on the harness connector.

- Are all connections clean and secure?

YES -- Leave anti-lock electronic control module connector disconnected. GO to 6.2. 6.2

NO -- Terminal(s) in component connector are corroded, bent, or loose. service terminals or connector as needed. If not serviceable replace anti-lock electronic control module. GO to 6.7. 6.7

NO -- Terminal(s) in harness connector are corroded, bent, or move back or come free of connector. Service terminals or connector as needed. GO to 6.7. 6.7