Manufacturer Code Charts: 6: 6.2

- Verify ignition is OFF.

- Remove speed sensor connector.

- Inspect speed sensor component connector for contamination and bent or loose terminals.

- Gently pull on Circuit 519 (LG/BK) behind Pin B of harness connector.

- Gently pull on Circuit 523 (R/PK) behind Pin A of harness connector.

- Are all connections clean and secure?

YES -- Reinstall RABS speed sensor connector. Go to 6.3. 6.3

NO -- Terminal(s) in component connector are corroded, bent, or loose. Service terminal or connector as needed. If not serviceable, replace RABS speed sensor. Go to 6.7. 6.7

NO -- Terminal(s) in harness connector are corroded, bent, or move back or come free of connector. Service terminal or connector as needed. Go to 6.7. 6.7