System Pre Check

Connector Diagram:

DESCRIPTION
Code 9 is generated by the anti-lock electronic control module's detection of high speed sensor resistance. The anti-lock electronic control module will consider the speed sensor circuit to have a high resistance when it exceeds approximately 3 k Ohms. The code may also be generated by a failed internal anti-lock electronic control module circuit.

POSSIBLE CONTRIBUTING BASE BRAKE COMPONENT/VEHICLE WIRING CONCERNS
- Terminal backout in the anti-lock electronic control module harness connector at Pin 3 or Pin 10
- Terminal backout in the RABS speed sensor harness connector at Pins A or B
- Module or RABS speed sensor connector not fully mated with component
- Open or intermittent open circuit in Circuits 519 (LG/BK) or 523 (R/PK)

NOTE: Use Rotunda(r) 73 Digital Multimeter 105-00051 or equivalent for electrical tests.