Removal and Installation

Removal

Headlamp Assembly:

1. Disconnect wiring from the back of the headlamp housing (13100) by grasping the wires and carefully "snapping" rearward.

2. Remove radiator grille (8200).

3. Remove the three retainers securing the headlamp to the opening panel in radiator grille.

4. Remove the headlamp (13008) from the vehicle by pulling it forward.

5. Transfer the headlamp bulb retainer (13N019) and the headlamp adjusting screw (13032) to the replacement headlamp if service lamp kit is not being used.

Installation

1. NOTE: The lower outboard aiming screw installs into a slide track on the opening panel of radiator grille while inserting it into the attachment hole.

Position the lamp to the opening in radiator grille panel making sure the locating pin is installed in the aiming screw. Align and insert the three attaching studs.

2. Install the three retainers securing the headlamp to the grille opening panel.

3. Connect wiring.

4. Install radiator grille.

5. Check headlamp aim.