Accelerator Pedal: Service and Repair

Removal

1. Disconnect accelerator cable from accelerator pedal assembly.

2. Disconnect kickdown cable from accelerator pedal assembly, if so equipped.

3. Remove bolt attaching accelerator pedal assembly to dash panel and remove accelerator pedal assembly.

Installation

1. Position accelerator pedal assembly to dash panel and install attaching bolt (and J-nut on Aerostar only). Tighten to 9-12 Nm (80-106 lb.in.).

2. Connect accelerator cable and kickdown cable to accelerator pedal assembly.

Accelerator Cable Bracket

Removal and Installation

1. Remove the accelerator control splash shield, if equipped.

2. Remove the accelerator cable from the accelerator cable bracket.
3. Remove the kickdown cable from the accelerator cable bracket, if equipped.

4. Remove the accelerator cable bracket holding screws and remove the accelerator cable bracket from the upper intake manifold .

For installation follow removal procedures in reverse order.

Specifications