Lock Cylinder Functional
Ignition Switch Lock CylinderNOTE: The following procedure applies to vehicles that have functional lock cylinders and keys. If key numbers are known, the proper key can be made.
Lock Cylinder Functional
Removal
1. Disconnect battery ground cable (14301).
2. Turn lock cylinder key to RUN position.
3. Remove lower shroud as outlined in this section under shroud removal.
4. Place a 3.17mm (1/8-inch) diameter wire pin or small drift punch in hole in steering column under lock cylinder. Depress retaining pin while pulling out on lock cylinder to remove it from housing of steering column.
Installation
1. Install lock cylinder by turning it to RUN position and depressing retaining pin. Insert lock cylinder into steering column housing. Make sure ignition switch lock cylinder is fully seated and aligned in interlocking washer before turning key to OFF position. This will permit retaining pin of ignition lock cylinder to extend into hole of steering column.
2. Rotate lock cylinder, using key, to make sure of correct mechanical operation in all positions.
3. NOTE: When the battery (10655) has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module (PCM)(12A650) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more for powertrain control module to relearn the strategy. Connect battery ground cable.