Bench

REMOVAL
1. Disengage the lap/shoulder seat belt from the seat by pressing the release button on the safety belt buckle. Stow the tongue end of the detachable anchor.
2. Fold seat back forward and latch it in the down position.
3. Lift the rear seat back latch handles (located under seat near floor) upward simultaneously to disengage latch hooks from floor attachment.
4. Lift seat at rear and rotate about the forward attachment.
5. Pull the seat rearward to disengage it from the front floor pins and remove from vehicle.

CAUTION: Care should be taken when storing seats out of the vehicle so the latches are not damaged.







INSTALLATION
1. With the seat back in a folded and latched position, place the seat assembly in the vehicle and engage the front seat hooks onto the forward attachment pin in the floor wells.

WARNING: WHEN REINSTALLING A REAR SEAT IN YOUR VEHICLE IT MUST BE PLACED IN ITS ORIGINAL POSITION. IMPROPER INSTALLATION OF THE SEAT WILL PREVENT CORRECT USE OF THE SAFETY BELTS AND COULD INCREASE THE RISK AND/OR SEVERITY OF INJURY IN AN ACCIDENT. REFER TO THE WARNING LABEL ON THE SAFETY BELT.

2. Rotate the seat downward and engage the rear seat back latch hooks into the rear floor attachment. Lifting of the rear seat back latch handles is not required for installation.
3. Make sure that the rear seat back latch hooks are fully seated in the down position.
4. Before you engage the safety belt, make sure it is not twisted. Remove any twist, then insert the tongue end of buckle until you hear a snapping noise.