Disconnecting the Tester

1. Disconnect transmission tester from transaxle connector.

CAUTION: Do not attempt to pry off connectors with a screwdriver. This will damage the connector and could result in a transaxle concern.

2. Reinstall vehicle wiring harness. Verify connection by pulling up on the harness.
3. Reinstall all heat shields that were previously removed.
4. Disconnect transmission tester power cable from vehicle.
5. Erase all DTCs using.
6. Rerun On-Board Diagnostics (OBD) to receive a pass code (P1111).
7. Verify that the customer concern has been eliminated.