Ride Height Sensor: Service and Repair

REMOVAL
1. Raise vehicle on a hoist.

WARNING: TURN OFF REAR SUSPENSION LEVELER COMPRESSOR SWITCH TO PREVENT INJURY.





2. Disconnect air suspension height sensor electrical connector.





3. Disconnect bottom and then top end of air suspension height sensor by pushing and holding spring clip back.

NOTE: Before removing air suspension height sensor (5359) from ball studs, observe depth of studs in air suspension height sensor.





4. Pull air suspension height sensor away from ball stud while holding spring clip back.

CAUTION: When removing or installing air suspension height sensor, grasp body of air suspension height sensor air suspension height sensor as close as possible to the attaching ends. Do not use a bending force near the center of the air suspension height sensor body or damage to the air suspension height sensor may occur.





INSTALLATION
1. Connect top and then bottom end of air suspension height sensor to ball studs. Push air suspension height sensor onto stud until spring clip snaps in place. Make sure ball studs are fully seated in air suspension height sensor ball stud retainer housing.
2. Connect electrical connector.
3. Lower vehicle.
4. Turn on air suspension service switch.