Suspension Mode Switch: Service and Repair
REMOVAL1. Turn off rear air suspension service switch.
2. Remove the jack storage trim panel.
3. Remove screw and pull switch board out to access electrical connector.
4. Disconnect electrical connector.
5. Push retaining clips retaining switch to board assembly and remove rear air suspension service switch.
INSTALLATION
1. Push rear air suspension service switch into position in board assembly. Ensure switch retaining tabs are fully seated.
2. Connect electrical connector.
3. Align bottom tab of switch board to body sheet metal.
4. Insert screw and tighten to 1.3 Nm (12 inch lbs.).
5. Turn on rear air suspension service switch.
6. Install RH jack stowage trim panel.