Speed Control Switch

REMOVAL

WARNING
^ REFER TO AIR BAGS (SUPPLEMENTAL RESTRAINT SYSTEMS) FOR AIR BAG SYSTEM OPERATION AND SPECIAL HANDLING PROCEDURES. FAILURE TO ADHERE TO THESE PROCEDURES MAY RESULT IN AIR BAG DEPLOYMENT WHICH COULD RESULT IN PERSONAL INJURY.
^ THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, BOTH BATTERY CABLES MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENT.
^ PLACE DRIVER SIDE AIR BAG MODULE IN BENCH WITH TRIM COVER FACING UP.
^ THE BACKUP POWER SUPPLY MUST BE DISCONNECTED BEFORE ANY AIR BAG COMPONENT IS SERVICED.

NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.

1. Remove driver side air bag module from steering wheel.
2. Disconnect horn/speed control black wire harness connection from clockspring contact connector located in upper center of steering wheel.
3. Remove two retaining screws from base of each speed control actuator switch.
4. Remove electrical tape from wire connectors located at each upper clip in steering wheel.
5. Disconnect speed control switch wires at untaped wire connectors and remove switches.

INSTALLATION
1. For installation, follow removal steps in reverse order.