Climate Control Assembly Switches

REMOVAL
1. Disconnect battery ground cable.
2. Remove the heater control from the instrument panel.
3. Remove the knob from the heater blower motor switch.
4. Pull the heater control through the instrument panel opening far enough to allow removal of the electrical connector.
5. Remove the electrical connector from the heater blower motor switch by lifting the snap-lock retainer with a screwdriver. Pull on the connector until it separates.
6. Remove the hex-head screw which attaches the heater blower motor switch to the bracket of the heater control and remove the heater blower motor switch.

INSTALLATION
1. For installation, follow removal steps in reverse order.
2. Check system for proper operation.