Toe

1. Start the engine. Move steering wheel into straight-ahead or centered position.
2. Turn the engine off, and lock the steering wheel in place using a steering wheel holder.
3. Check the toe reading.
4. If toe is not within specifications, remove bellows seal clamp if used.
5. Loosen the jam nuts and adjust toe to 0.80 mm (1/32 inch) IN for the preferred setting.

NOTE:
^ Whenever the jam nuts are loosened for toe adjustment, the nut and tie threads must be cleaned and lubricated and the jam nut retightened to 80 Nm (59 ft. lbs.).
^ Free the boot from the rod before attempting to adjust toe. Do not allow boot to twist when rod is turned for toe adjustment.

6. Hold tie rod end with wrench while tightening in jam nut.
7. Replace bellows seal clamp, if used after tightening jam nut.