With Manual A/C-Heater

REMOVAL
1. Disconnect battery ground cable.
2. Remove the air cleaner or air inlet duct as necessary.
3. Remove two screws attaching the A/C vacuum reservoir tank and bracket to the A/C blower housing and remove the reservoir.
4. Disconnect wire harness connector from blower motor by pushing down on connector tabs and pulling connector off blower motor.
5. Disconnect blower motor housing tube at blower motor.
6. Remove the A/C cycling switch from the suction accumulator/drier.
7. Remove three screws attaching blower motor to the A/C blower housing.
8. Holding blower motor housing tube aside, pull blower motor from the A/C blower housing.
9. Remove clamp from the shaft. Then, pull the A/C evaporator core housing from the shaft.

INSTALLATION
1. For installation, follow removal steps in reverse order.
2. Check system for proper operation.

NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16km (10 miles) or more to relearn the strategy.