Keyless Entry Transmitter: Service and Repair

REMOTE TRANSMITTER PROGRAMMING
To program a keyless entry remote transmitter, perform these steps:

1. Enter the five digit permanent entry code into keyless entry keypad.

NOTE: The permanent entry code for the driver door module is viewed by requesting the PID-KEY CODE on Rotunda New Generation Star (NGS) Tester 007-00500 or equivalent.

2. Within five seconds of pressing last button of permanent code, press the 1/2 button.
3. Press LOCK button on first keyless entry remote transmitter within five seconds of pressing the 1/2 button.
4. Press any button on second keyless entry remote transmitter within five seconds of pressing the first transmitter LOCK button.
- After each successful transmitter reprogramming, the doors will signal by locking and unlocking.
- If keyless entry keypad illumination goes out before all transmitters are reprogrammed into driver door module, the process must be repeated beginning with Step 1.
- Up to four transmitters may be programmed to a vehicle in this manner.