Lock Cylinder Switch: Service and Repair

REMOVAL






NOTE: In the images, the steering wheel is removed for clarity.

1. If equipped, twist the tilt wheel handle and shank and remove.
2. Remove the lower steering column shroud.






1. Remove the three lower steering column shroud screws.
2. Remove the lower steering column shroud.

3. Remove the ignition switch lock cylinder.






1. Insert the ignition key into the ignition switch lock cylinder and turn to RUN position.
2. Push the (A) ignition switch lock cylinder release tab with a punch while pulling out the (B) ignition switch lock cylinder.






4. Carefully pry to release the four clips and remove the steering column opening cover.






5. Remove the upper steering column shroud.
6. Remove the upper instrument panel steering column cover.
7. Remove the ignition lock anti-theft switch.






1. Disconnect the electrical connector.
2. Remove the ignition lock anti-theft switch.

INSTALLATION











1. To install, reverse the removal procedure.