External Sealing

The E4OD transmission has the following parts to prevent external fluid leakage:
- gaskets
- lip-type seals
- O-ring seals
- seal rings
- seal grommets
- thread sealant cooler bypass valve (CBV) sealing washers

Leakage at the transmission pan-to-case gasket often can be stopped by tightening the retaining bolts to specification. If necessary, replace the pan-to-case gasket.

If leakage is found by the solenoid body connector. Replace the O-ring on the connector snout of the solenoid body assembly.

Check the transmission fluid filler tube connection at the transmission case. If leakage is found, install a new short fluid inlet tube.
Check the transmission fluid lines and fittings between the transmission and the fluid inlet short tube in the radiator tank for looseness, wear or damage. If leakage cannot be stopped by tightening a fluid line tube nut, replace the damaged parts. When fluid is found to be leaking between the case and the cooler line fitting, tighten the fitting to maximum specification.

CAUTION: Do not try to stop the fluid leak by increasing the torque beyond specification. This can cause damage to the case threads.

If the leak continues, replace the cooler line fitting and tighten to specification. The same procedure should be followed for fluid leaks between the radiator cooler and cooler line fittings.

Check the engine coolant in the radiator. If transmission fluid is present in the coolant, the transmission fluid cooler in the radiator is probably leaking.

The transmission fluid cooler can be further checked for leaks by disconnecting the lines from the cooler fittings and applying no more than 345 kPa (50 psi) air pressure to the fittings. Remove the radiator cap to relieve the pressure buildup at the exterior of the fluid cooler tank. If the transmission fluid cooler is leaking, will not hold pressure, or both, replace the transmission fluid cooler.

If leakage is found at the manual control lever shaft, replace the seal.

When a converter drain plug leaks, remove the drain plug. Install and tighten a new drain plug to specification.

Check for fluid leaking from the end of the extension housing. Leakage can result from a damaged seal, missing garter spring or worn extension bushing, or damaged speedometer plug. Replace the seal assembly, bushing, or both, as necessary.

Inspect the line pressure plugs for leakage. Make sure they are tightened to specification. If tightening does not stop the leak, replace the plug.

Check for leakage on or around the cooler bypass valve (CBV). Repair as required.