Autolock

All doors will automatically lock each time the vehicle is driven after the these steps are completed:
^ The ignition switch is in the RUN/ACC position and the autolock feature is enabled.
^ The shift control selector is passed into and out of the reverse (R) position.
^ All doors, liftgate and liftgate window are closed when the driver releases the brake pedal.

After the initial lock, all doors will automatically relock when any door is opened and then closed followed by the release of the brake pedal. However, the doors will not relock if the ignition switch is in the OFF position.

The door may not automatically lock if:

^ The vehicle is shifted quickly into gear after starting the engine

Enabling and Disabling: The enable/disable mode allows the autolock feature to be turned off and on.

Enabling and Disabling Using Keyless Entry Keypad
1. Enter the five-digit permanent entry code into the keyless entry keypad.
2. Within five seconds of entering the code, press and hold the 7/8 button on the keypad.
3. Within five seconds of Step 2, and while holding the 7/8 button, press the 3/4 button on the keypad and release it.
4. Within five seconds of Step 3, release the 7/8 button on the keypad.

If the autolock feature is disabled, the horn will chirp once. If the autolock feature is enabled, the horn will chirp once shortly and then a second time with a longer honk once the sequence is completed.

Enabling and Disabling Using Power Door Lock/Unlock Switch
Another way to turn the autolock off/on is by this series of steps:
1. Confirm that the perimeter alarm is disarmed.
2. Close all of the doors.
3. Confirm that the ignition switch is in the OFF position.
4. Turn the ignition switch from OFF to RUN.

NOTE: Steps 4 through 8 must be performed within 30 seconds.

5. Press the power door lock UNLOCK button three times.
6. Turn the ignition switch from RUN to OFF.
7. Press the power door lock UNLOCK button three times.
8. Turn the ignition switch from OFF to RUN.
9. Verify that the RAP module chirps the horn. This indicates that the RAP module is now in the enable/disable mode and ready to accept program changes.
10. Press the power door lock UNLOCK button one time to command the RAP module to toggle the autolock/relock feature OFF
11. Press the power door lock LOCK button once to enter the command.
12. Verify that the horn chirps one time to signal the RAP module confirmation of the command. There should only be one chirp indicating that autolock/relock feature has been disabled. If one chirp is heard, followed by a longer honk, the autolock/relock feature has just been enabled. Return to step 10.
13. Turn the ignition switch to the OFF position to exit the enable/disable mode.
14. Exit the vehicle and verify that the RAP module chirps the horn once to indicate that a feature has been changed and that autolock/relock has been disabled.