Removal and Installation

WARNING: USE ONLY PROPERLY INSTALLED FCC APPROVED RADIO TRANSMITTING EQUIPMENT. USE OF OTHER TRANSMITTING EQUIPMENT MAY CAUSE THE VEHICLE TO MALFUNCTION OR STALL. IF THE ENGINE STALLS, POWER BRAKE AND POWER STEERING ASSIST WILL STOP. CONSULT YOUR AUTHORIZED DEALER BEFORE INSTALLING ANY RADIO TRANSMITTER.







REMOVAL
1. Disconnect battery ground cable.
2. Install Radio Removing Tool into radio face plate. Push tools in approximately 25.4 mm (1 inch) to release retaining clips.

CAUTION: Do not use excessive force when installing radio removal tool, as this will damage retaining clips and make radio chassis removal difficult.


3. Apply a slight spreading force on tools and pull radio chassis from instrument panel.
4. Disconnect the wiring connectors and remove antenna cable and the radio chassis.

INSTALLATION
1. Connect wiring connectors and antenna cable to radio chassis.
2. Slide radio chassis into instrument panel, making sure that rear radio chassis support is engaged on support rail.
3. Push radio chassis inward until retaining clips are fully engaged.
4. Connect battery ground cable