Bare Block

NOTE: Before replacing a cylinder block, determine if it is serviceable. If so, perform the necessary service.

DISASSEMBLY
1. Completely disassemble the engine, following the procedures in disassembly and assembly.
2. Remember to ridge ream the cylinder bores before removing piston assemblies.
3. Remove the cylinder head to block dowels and the cylinder block drain plugs.

ASSEMBLY
1. Clean the gasket and seal surfaces of all serviceable parts and assemblies.
2. Position the new cylinder block in a work stand and install the cylinder head to block dowels and the cylinder block drain plugs.
3. Transfer all serviceable parts removed from the used cylinder block, following the procedures in disassembly and assembly.
4. Check all assembly clearances and correct as necessary.