Manufacturer Code Charts: 10: 10.7
10.7 CLEAR CODES/PULL CODES- Key "OFF."
- Reconnect the battery ground cable.
- Verify that all connectors are installed.
- Locate and disconnect the diagnostic connector from its mating half (Circuits 571 [BK/O] and 483 [R]).
- Key "ON."
- Begin the diagnostic trouble code flashout by connecting Circuit 571 (BK/O) to a chassis ground for at least 1 second.
- Observe and count the code.
Is Code 16 set?
> Yes
Go to Drive Test Code 16. Drive Test 1 Code 16
> No
If Code 10, Go to Pinpoint Test 10.8. 10.8
If a different code, Go to Pinpoint Test for the corresponding code.