Torque Specifications

1. Time required for plunger to leak down (3.18mm 1/8 in.) of travel with (22.68 kg 50 lb.) load leak-down fluid in lash adjuster.

2. Distance in inches that front bearing is installed below front face of bearing tower.

3. 0.002 undersize = add 0.001 to standard thickness.

4. Pin bore and crank bearing bore must be parallel and in the same vertical plane, within the specified total difference when measured at the ends of an 8 in. bar - 4 in. on each side of rod centerline.

5. Measured at 14.58mm from bottom of skirt, centerline - 90° to the pin.

6. Add one quart with filter change.

7. On engine, temperature normal, curb idle, in neutral, brakes set.

8. Pump to tank return line pinched off, new fuel filter in line.

9 Smallest orifice = no less than 0.220 in. I.D.

10. Torque in sequence in two steps:
- Step 1: 34-41 N.m (25-30 lb-ft).
- Step 2: 39-41 Nm (28-30 lb-ft).

11. Install cylinder head bolts in sequence. Tighten in sequence to 70 Nm (51 lb-ft). Retighten in sequence to 70 Nm 51 (lb-ft). Turn all cylinder item bolts an additional 90-100 degrees in sequence.

12. Torque in sequence in two steps:
- Step 1: 20-30 N.m (15-22 lb-ft).
- Step 2: 60-80 N.m (44-59 lb-ft).

13. Torque in sequence in two steps:
- Step 1: 7-10 Nm (62-88 lb-in).
- Step 2: 26-38 N.m (19-28 lb-ft).

14. Torque in sequence in two steps:
- Step 1: 68-81 N.m (50-60 lb-ft).
- Step 2: 102-115 N.m (75-85 lb-ft).

15. 1/2 turn after gasket contacts surface - oil gasket.