Removal and Installation

REMOVAL
1. Using a 14 mm wrench, remove eight retaining bolts from extension housing. Pry gently at locations provided on extension housing and case. Remove extension housing from case.

NOTE: If it is necessary to remove oil seal, the extension housing must be installed to case. Remove oil seal using extension housing Seal Remover T74P-77248-A.





2. If necessary, remove rear oil bypass tube from extension housing using a 1O mm socket.

INSTALLATION
1. Position extension housing to case and install retaining bolts. Tighten bolts to 32-46 Nm (24-34 ft. lbs.).





2. If removed, install input shaft and extension housing seal using Extension Housing Seal Replacer T61L-7657-A. Make sure that oil seal drain hole faces downward.