Cruise Control Servo: Service and Repair

REMOVAL
1. Remove the screw(s) that mount speed control bracket to vehicle.
2. Disconnect speed control 10-way connector.
3. Depress accelerator pedal and shaft, then push locking arm on speed control actuator cap and rotate cap counterclockwise.

Speed Control Servo Rotor:

4. Remove cable ball slug from servo rotor.
5. Remove speed control actuator cable slug from speed control servo pulley. Gently push actuator cable slug past retaining spring using a small screwdriver.
6. Remove bracket from the speed control servo. Keep bracket, screw(s), eyelets and insulators for reuse.

INSTALLATION
1. Attach bracket to speed control servo with three screws, eyelets and insulators. Tighten to 6-7 Nm (53-62 Lb-In).
2. Attach speed control 10-way connector to speed control servo.
3. Make sure the rubber seal is fully seated on actuator cable cap.
4. Depress accelerator pedal and shaft if accelerator cable is attached to throttle and lock cable ball in slot located in servo pulley.
5. Release accelerator cable or pull accelerator cable at throttle end.
6. Insert cap locking tabs into speed control servo slots.
7. Rotate cap clockwise until locking arm engages locking tab on servo.
8. Position speed control actuator cable and mount with screws.
9. Adjust speed control actuator cable.