Manufacturer Code Charts: 6: 6.2

6.2 VERIFY THE INTEGRITY OF THE SPEED SENSOR CONNECTION

- Key "OFF."

- Remove the speed sensor component connector for contamination and bent or loose terminals.

- Gently pull on circuit 519 (LG/BK) behind Pin B of the harness connector.

- Gently pull on circuit 523 (R/PK) behind Pin A of the harness connector.

Are all connections clean and secure?

> Yes
Reinstall the RABS speed sensor connector. Go to Pinpoint Test 6.3. 6.3

> No
Terminal(s) in component connector are corroded, bent, or loose. Repair terminal or connector as needed. If not repairable, replace the RABS speed sensor. Go to Pinpoint Test 6.7.6.7

Terminal(s) in the harness connector are corroded, bent, or move back or come free of connector. Repair terminal or connector as needed. Go to Pinpoint Test 6.7. 6.7