Keyless Entry Transmitter: Service and Repair
PROGRAMMING PROCEDUREWhen the customer has purchased additional transmitters, or has lost a transmitter, the customer MUST bring to the dealer ALL of the transmitters for the vehicle. The dealer must then reprogram ALL of the transmitters at the same time. The receiver assembly module erases all previous transmitters from memory, when the transmitters are programmed or reprogrammed. The receiver assembly module can store up to four transmitters in memory.
To program (or reprogram) transmitter(s) into the remote/keyless entry module, perform these steps:
1. Make sure that the anti-theft system is not armed or triggered.
2. Turn the ignition key from OFF to RUN five times within 10 seconds, ending in RUN.
If the Remote Anti-theft Personality (RAP) system has successfully entered program mode, it will lock and then unlock all doors.
3. Press any button on a transmitter, and the doors will lock and then unlock to confirm that each transmitter has been programmed.
If the door locks do not respond for any transmitter, wait a few seconds and press the button again. If the door locks still fail to respond, go to Pinpoint Test A. A: Door Lock Motors/Switches Inoperative
4. Turn ignition OFF (or wait up to five minutes after Step 2) to exit program mode. If a new set of transmitters have been programmed (or reprogrammed), the remote control alarm and door lock system will lock and unlock all doors one last time to confirm.