Tip/Slide Seat

REMOVAL
1. Tilt seat back and slide seat to foremost position in vehicle.
2. Remove rear seat track insulators by releasing locking tabs from track.
3. Remove screws attaching seat track to floorpan.
4. Tilt seat back to upright position and slide seat rearward.
5. Remove front track insulators.
6. Remove screws from front seat track.
7. Disconnect electrical connector, if equipped.
8. Remove seat from vehicle.

INSTALLATION
For installation, follow removal procedures in reverse order.

NOTE: When installing seats into vehicle, follow sequence for attaching bolts/screws to floorpan. First, tighten front inboard fastener, second, front outboard, third, rear inboard and finally the rear outboard. Tighten screws to 19-26 Nm (14-19 Lb-Ft).