Manufacturer Code Charts: 4: 4.2

4.2 VERIFY THE INTEGRITY OF ANTI-LOCK ELECTRONIC CONTROL MODULE CONNECTION

- Key "OFF."

- Disconnect the battery ground cable.

- Inspect the anti-lock electronic control module component connector Pin 6.

- Inspect the anti-lock electronic control module harness connector Pin 6.

- Pull gently on Pin 6 wire just behind the harness connector.

Are connections clean and secure?

> Yes
Leave the anti-lock electronic control module connector disconnected. Go to Pinpoint Test 4.3. 4.3

> No
Terminal(s) in the anti-lock electronic control module connector are loose, bent, deformed, corroded, or missing. Repair terminal or connector as needed. If not repairable, replace the anti-lock electronic control module. Go to Pinpoint Test 4.10. 4.10

Terminal 6 in the harness connector moves back or comes free of connector. Repair terminal or connector as needed. Go to Pinpoint Test 4.10. 4.10