Horn Switch: Service and Repair

REMOVAL and INSTALLATION
1. Make sure the vehicle's front wheels are facing straight ahead, and the steering wheel is oriented in the straight-ahead position.
2. Disconnect the battery-to-starter relay cable. Wait at least one minute before proceeding to allow the air bag backup power supply to discharge.
3. Remove the driver side air bag module.
4. Disconnect the horn wire (V/LG) from the switch to be removed.
5. Remove two Torx(r) head retaining bolts and remove horn blow switch.
6. To install, reverse removal procedure. Ensure that no wires are trapped/pinched when the new horn switch is attached to the steering wheel. Tighten retaining bolts to 6.5-7.5 Nm (58-66 lb-in).