Steering: Service and Repair

Make the following preliminary checks before servicing the steering system. If hoses are to be disconnected, label them prior to removal so they can be easily identified for reassembly.

AIR BLEEDING
Verify the power steering pump has been filled. Run the engine until it reaches normal operating temperature. Turn the steering wheel to the left and right several times without hitting the stops. Recheck the fluid level and if any air bubbles are present, purge the power steering system of ai.

FLUID LEVEL
The fluid level can be checked either hot or cold, but use the appropriate mark on the dipstick. Check for bubbles in the fluid when taking a fluid level reading. If bubbles are evident, purge the power steering system of air. If a low level is indicated on the dipstick, add MERCON(R) Power Steering Fluid.

PUMP BELT
Check the tension of the belt. Adjust or replace as necessary.
NOTE: Drive belt tension adjust is not required on vehicles with drive belt tensioner.