Transmission Position Sensor/Switch: Service and Repair

REMOVAL
1. Use a screwdriver to remove the shift cable and fitting from the transmission lever ball stud.
2. Disconnect vehicle harness connector from digital transmission range (DTR) sensor by depressing tab.





3. Remove the manual control outer lever nut and manual control outer lever.





4. Remove the two M6 x 25 TR sensor screws and remove the DTR sensor.





INSTALLATION
1. Install the DTR sensor on the manual lever. Install the two TR sensor screws and finger tighten. Rotate the manual lever to the neutral position (two detents rearward).





2. Install Digital TR Sensor Alignment Tool T97L-70010-A into the three slots on the DTR sensor. Tighten the TR sensor-to-case screws to 8-11 Nm (71-97 inch lbs.). Remove the alignment tool.





3. Install the manual control outer lever and manual control outer lever nut. Tighten the manual control outer lever nut to 41-54 Nm (30-40 ft. lbs.).
4. Install shift cable or linkage from manual control lever. Use a screwdriver to remove the cable and fitting from the transmission lever ball stud.
5. Adjust shift cable.
6. Reconnect vehicle harness connector to DTR sensor.