Quick Test 2.0 - Set Up

Connect Rotunda New Generation STAR Tester 007-00500 or equivalent to Data Link Connector.

The following are steps to run OBD II procedures.
Prepare the vehicle as follows:
- Transmission range selector lever in PARK.
- Engine to operating temperature.
- Apply parking brake.
- Block wheels.
- Turn off all electrical loads including A/C and defroster. (If A/C is ON, DTC P1460 will set.)





Prepare the NGS as follows:
- Key OFF.
- Verify that the proper program card is inserted in the NGS.
- Connect J1962/16-way DCL cable adapter to the NGS.
- Connect NGS DCL cable adapter securely into the vehicle's DCL connector.
- Connect the NGS power supply cable to the vehicle battery power supply through cigarette lighter or at the battery with alligator clip adapter.
- Key ON or start vehicle if necessary.
The NGS is now ready to communicate with the PCM.